INFLUENCE OF ADDITIONAL Pa CONTROLLER TO THE SYSTEM RESPONSE WHEN THE SET POINT IS CHANGING

Једноставна страница ставке
dc.citation.epage233
dc.citation.spage228
dc.citation.volume5
dc.contributor.authorProdanović, Saša
dc.contributor.authorDubonjić, Ljubiša
dc.contributor.authorNedić, Novak
dc.contributor.editorRadić, Nebojša
dc.contributor.editorProdanović, Saša
dc.date.accessioned2024-03-28T13:19:22Z
dc.date.available2024-03-28T13:19:22Z
dc.date.issued2020-11
dc.description.abstractOne of the numerous approaches for disturbance rejection is occasionally introducing additional Pa term in parallel to the existing controller. It is strongly important to check effects of its operation to the system's transient processes caused by instant changes of set point, because it is well known that too high values of P term can lead system into unstable state. Therefore, this paper deal with researching of maximum proportional gain that can be used for disturbance rejection if it appear in the transient process (dynamical area of system response). Investigation has been carried out using numeric simulations, on the some characteristic process examples, that were considered in the previous survey of mentioned additional Pa controller.
dc.identifier.isbn978-99976-719-8-1
dc.identifier.urihttps://vaseljena.ues.rs.ba/handle/123456789/1110
dc.language.isoen
dc.publisherMašinski fakultet Istočno Sarajevo, Univerzitet u Istočnom Sarajevu
dc.sourceZbornik radova COMETa
dc.subjectadditional Pa controller, maximum proportional gain, set point changes
dc.titleINFLUENCE OF ADDITIONAL Pa CONTROLLER TO THE SYSTEM RESPONSE WHEN THE SET POINT IS CHANGING
dc.typeArticle
Датотеке
Оригинални завежљај
Сада се приказује 1 - 1 од 1
Сличица
Име:
COMETa2020_dubonjic.pdf
Величина:
380.9 KB
Формат:
Adobe Portable Document Format
Опис:
Преузимање
Свежањ лиценце
Сада се приказује 1 - 1 од 1
Сличица
Име:
license.txt
Величина:
1.71 KB
Формат:
Item-specific license agreed to upon submission
Опис:
Преузимање
Колекције
Машински факултет [Конференције] / Faculty of Mechanical Engineering [Conference paper]