PREDICTING SURFACE ROUGHNESS IN THE MILLING OF BIOCOMPATIBLE ALLOY TI–6AL–4V

Једноставна страница ставке
dc.citation.epage20
dc.citation.spage13
dc.citation.volume22
dc.contributor.authorBabić, Igor
dc.contributor.authorŠikuljak, Lana
dc.contributor.authorKošarac, Aleksandar
dc.contributor.authorMoljević, Slaviša
dc.contributor.authorSekulić, Milenko
dc.contributor.authorSavković, Borislav
dc.contributor.authorAleksić, Anđelko
dc.contributor.editorKiss, Imre
dc.date.accessioned2024-10-30T12:47:54Z
dc.date.available2024-10-30T12:47:54Z
dc.date.issued2024-05
dc.description.abstractMechanical engineering plays an essential role in the development of medical devices, implants, prostheses, and medical equipment, with precise machining of bio–compatible materials being of considerable importance. Among the various traditional and modern machining methods, milling stands out as a widely employed technique. This study is dedicated to optimizing milling parameters to achieve a minimal average surface roughness (Ra) during the milling of the biocompatible alloy Ti–6Al–4V. This paper presents the optimization of machining parameters: cutting speed, feed rate and depth of cut. Each parameter is explored at three distinct levels, resulting in the initial design of 27 experimental runs. The paper further demonstrates how an extensive set of experiments can be streamlined to a more manageable 9 runs through the application of the Taguchi methodology. This paper points out the significant impact that varying levels can exert on the obtained results, highlighting the importance of a comprehensive and systematic approach to experimentation and optimization.
dc.identifier.issn1584-2665
dc.identifier.urihttps://vaseljena.ues.rs.ba/handle/123456789/1223
dc.language.isoen
dc.publisherUniversity Politehnica Timisoara, Faculty of Engineering Hunedoara
dc.sourceAnnals of Faculty Engineering Hunedoara – International Journal of Engineering
dc.subjectAverage surface roughness (Ra), difficult–to–cut materials, Ti–6Al–4V, ANOVA, Taguchi method
dc.titlePREDICTING SURFACE ROUGHNESS IN THE MILLING OF BIOCOMPATIBLE ALLOY TI–6AL–4V
dc.typeArticle
Датотеке
Оригинални завежљај
Сада се приказује 1 - 1 од 1
Сличица
Име:
ANNALS-2024-2-01.pdf
Величина:
1.38 MB
Формат:
Adobe Portable Document Format
Опис:
Преузимање
Свежањ лиценце
Сада се приказује 1 - 1 од 1
Сличица
Име:
license.txt
Величина:
1.71 KB
Формат:
Item-specific license agreed to upon submission
Опис:
Преузимање
Колекције
Машински факултет [Научни радови] / Faculty of Mechanical Engineering [Scientific papers]