LAYER THICKNESS INFLUENCE OF MACRO- AND MICROSTRUCTURE QUALITY OF 3D PRINTED PARTS

dc.citation.epage500
dc.citation.spage495
dc.contributor.authorĐurić, Aleksija
dc.contributor.authorGojković, Ranka
dc.contributor.authorMarković, Biljana
dc.contributor.authorMoljević, Slaviša
dc.contributor.authorAnić, Jelica
dc.date.accessioned2023-10-20T11:39:47Z
dc.date.available2023-10-20T11:39:47Z
dc.date.issued2019
dc.description.abstractIn this paper will be analyzed the influence of the layer thickness on the micro and macro structure of the parts obtained by 3D printing, i.e. fused filament fabrication (FFF) technology. Specimens for analysis will be printed on the 3D printer Zotrax M 200, and the macro and microstructure will be done on the VHX 6000 microscope. It will be shown in the paper that by increasing the thickness of the layer, the time required for the production of the part will be significantly reduced, but also the quality of the surface is also significantly affected.
dc.identifier.issn2620-2832
dc.identifier.urihttps://vaseljena.ues.rs.ba/handle/123456789/869
dc.language.isoen
dc.publisherFaculty of Engineering, University of Kragujevac
dc.source13th International Quality Conference
dc.subject3D printing, Fused filament fabrication, layer thickness
dc.titleLAYER THICKNESS INFLUENCE OF MACRO- AND MICROSTRUCTURE QUALITY OF 3D PRINTED PARTS
dc.typeArticle
Датотеке
Оригинални завежљај
Сада се приказује 1 - 1 од 1
Учитавање...
Сличица
Име:
LAYER THICKNESS INFLUENCE OF MACRO- AND MICROSTRUCTURE QUALITY OF 3D PRINTED PARTS.pdf
Величина:
710.25 KB
Формат:
Adobe Portable Document Format
Опис:
Свежањ лиценце
Сада се приказује 1 - 1 од 1
Учитавање...
Сличица
Име:
license.txt
Величина:
1.71 KB
Формат:
Item-specific license agreed to upon submission
Опис: